Brinkmann Charcoal/Wood Smoker Step, Top View, Smoker Chamber, Hex Nut, Wire Rack, Bottom View

Step 5

Top View Bottom View

Install the leg brace (without the L-bracket) to the mounted legs using four self tapping screws. Securely tighten the screws and leg hex nuts. Do not overtighten.

Step 6

Smoker

Chamber

4" Hex Nut

4" Flat Washer

Attach the other two legs (with wheel axles) to the smoker. First, insert the wire rack into the leg, then move bolted end of leg until bolts align with holes in the cooking chamber. Insert bolts and place a flat washer and hex nut over each bolt and hand tighten only. Repeat this step on last leg.

NOTE: Leg brace with L-bracket is not attached until Step 10, after the firebox has been attached and the smoker is in an upright position.

Step 7

To install air vent damper, open the firebox lid and attach damper to inside of firebox as illustrated. Do not overtighten as this will make the air vent difficult to open and close.

Step 8

Leg Brace without	Wire Rack
L-Bracket
	Legs with Axles
	Air Vent
	Butterfly Damper

Close firebox lid. Carefully place the firebox on top of the large chamber. Open firebox lid and align the holes of both chambers and secure with 4" x w" bolts. Use two flat washers per bolt as illustrated (one in the firebox and one in the cooking chamber).

Step 9

Keeping lids closed and with the help of an assistant, carefully turn the smoker to its upright position. Try to minimize the stress placed on the legs.

CAUTION: Keep lids closed when setting unit upright to prevent bodily injury.

4" Flat Washer

4" x w" Bolt

Flat

Washer

4" Hex Nut

4" Flat Washer

Firebox

Begin

Bolting

Here

Cooking

Chamber

5