Harness Height Adjustment | Britax Regent specs

Harness Height Adjustment

1Loosen the harness by lifting the harness release lever while pulling the shoulder straps forward as far as possible (Fig. A).

2From the rear of the child seat, unhook the shoulder harness straps from the yoke (Fig. B).

3Pull the harness straps through the shell, foam and cover to the front of the child seat.

4Thread the harness straps through the appropriate harness slots in the cover, foam and seat shell. (Fig. C).

5Reattach harness straps to the harness yoke.

WARNING! HUGS™ chest pads must be used at all times.

6Pull harness adjuster strap to tighten the harness.

7Verify that all straps are threaded at the same height and are not twisted.

A

B

C

Adjusting Buckle Position

The buckle has two positions and should be adjusted to ﬁt your child (Fig. A). Select the slot closest to, but not under, the child.

WARNING! Do not use position two (2)	A
until child exceeds 50 pounds (22.7 kg).

Remove the buckle, then rethread in appropriate position. See page 36 for buckle removal and rethreading instructions.

32

33

Image 18

Britax Regent manual Harness Height Adjustment, Adjusting Buckle Position

Contents

Page Table of Contents Never route the vehicle belt over the child Safety Information CertiﬁcationRegistration Forward-Facing Child Seat Features Vehicle Seating Positions Vehicle Safety BeltsCannot be used. See diagram below Vehicle Compatibility Installation for Children 22 40 lbs Latch Long RouteVehicle Latch anchor limit Lap-Shoulder Belt Long Route Lap Belt Long Route To the front of the child seat shell Near the vehicle buckle Fig. C Installation for Children 40 80 lbsLatch Short Route Short route conﬁguration Fig. a Attach the Versa-Tetherhook to the vehicle’s designated Reach through the belt slots to access the loop endsLatch connector strap Fig. G Pages 26 Lap-Shoulder Belt Short Route Seat Fig. B Lap Belt Short Route Seat Fig. C26 27.D Using the Versa-Tether Versa-Tether Using Child Seat Features Using the Chest ClipUsing the Recline Bar Belt Routing with the Recline Bar Securing Your Child Unfasten the buckle by pressing down onMiddle button Move the harness straps to the side Harness Height Adjustment Adjusting Buckle Position Care and Maintenance Cover Removal Heard after inserting the second buckle Front of the child seatUnfastening until a Positive Lubricate Use solvents Use soap or household detergents Warranty Limited ONE-YEAR Warranty