Care and Maintenance
Cover Removal
WARNING! Do not take apart the harness. Never remove the buckle tongues from the harness. They cannot be reattached after removal. If reassembled incorrectly, the child
seat may not perform as intended.
1Loosen the harness by lifting the harness adjuster lever while pulling the shoulder straps forward as far as possible.
2Unhook the shoulder straps from the harness yoke on the rear of the child seat (Fig. A).
3Pull the upper harness straps through the A shell and cover to the front of the child seat.
4Remove the buckle and belly pad. See page 36.
5Gently remove the upper portion of the cover. Be careful not to damage the
6Pull the lower harness straps, buckle tongues, HUGS™ chest pads, and chest clip through the lower slots in cover.
7Remove the entire cover from the child seat.
For additional demonstration please visit www.BritaxUSA.com.
Refitting the Cover
To refit the cover, reverse the above directions. Make sure that the shoulder straps are not twisted, and are threaded properly through the chest clips, cover, foam, and shell.
Care and Maintenance
Cleaning the Cover
sHAND WASH using cold water and mild soap.
sLINE or
sDO NOT bleach, machine wash, machine dry or iron.
Cleaning the Shell
sSPONGE CLEAN using warm water and mild soap.
sTOWEL DRY
sDO NOT use solvents, abrasive cleaners or disassemble the harness.
Cleaning the Harness
sSPONGE CLEAN using warm water and mild soap.
sTOWEL DRY
sDO NOT bleach, machine wash, machine dry or disassemble the harness.
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it is clean and free of food, drink or other debris. If debris is present, it must be removed to prevent interference with the adjuster mechanism.
sBRUSH AWAY LOOSE DEBRIS using a
sSPONGE CLEAN using warm water and a mild soap.
sTOWEL DRY
sDO NOT use solvents, abrasive cleaners or disassemble the harness.
34 | 35 |
