Using the Recline Bar
s | The recline bar must be installed before using this |
|
| restraint. |
|
1 | Insert the recline bar into the holes in lower |
|
| rear of child seat prior to installation in vehicle |
|
| (Fig. A). |
|
2 | Use a rubber mallet to tap the recline bar | A |
| ends into holes (Fig. A). |
sDo not strike the center of the recline bar near the label as this may bend the recline bar.
3Ensure that the bottom of the child seat shell is in full contact with the vehicle seat and the recline bar is resting against the vehicle seat
back (Fig. B). | B |
|
Belt Routing with the Recline Bar
The recline bar is provided to improve stability of the child seat. Proper installation is key to ensuring the best performance of the child seat.
Long Route Installation
When using the long route installation, the C LATCH strap or vehicle belt strap must pass outside of the recline bar. (Fig. C)
Short Route Installation |
|
When using the short route installation, the |
|
LATCH strap or vehicle belt strap must pass | D |
through the inside of the recline bar. (Fig. D) | |
EXCEPTION: When using the |
|
however, the strap must pass on the outside of the recline bar.
Using Child Seat Features
Using the Chest Clip
Open the chest clip by squeezing the middle 
tabs, while pulling the two pieces apart (Fig. A). 
IMPORTANT: The correct height for the chest clip 
is at the middle of the chest, level with the armpit. | A |
Using the Buckle |
|
Fastening the Buckle
1 Hold the buckle with one hand.
2 Use your other hand to insert one tongue at 
a time into the buckle. Proper connection is confirmed with a positive click, after inserting the second buckle tongue (Fig. B).
Releasing the Buckle | B |
1Hold the buckle with one hand.
2Use thumb to press release button to eject the tongues from buckle (Fig. B).
NOTE: Periodically clean the buckle to ensure proper operation. See page 37.
28 | 29 |
