WIRING
! CAUTION: All electrical wiring should be done by a qualified person (s) in accordance with all applicable codes and standards. This range hood must be properly grounded.
Do not turn power on at service panel until all wires have been connected.
Blower connection at hood:
1.Run
2.Remove the cover from the wiring box and remove one knockout.
3.Feed 6” of cable through the knockout opening and secure the cable to the wiring box with an appropriate connector.
4.Make electrical connections at the hood. Connect
5.Replace the wiring box cover and screws. make sure wires are not pinched between the cover and box.
Exterior or In-Line blower connection:
1.Make electrical connections at the exterior or
Power connection at hood:
1.Run 120 VAC electrical power cable to the hood wiring box marked “120VAC input”.
2.Remove the cover from the wiring box and remove one knockout.
3.Feed 6” of cable through the knockout opening and secure the cable to the wiring box with an appropriate connector.
4.Make electrical connections at the hood. Connect
5.Replace the wiring box cover and screws. Make sure wires are not pinched between the cover and box.
BLOWER CONNECTION AT HOOD
Exterior or
blower
CONNECT:
BOX MARKED “MOTOR CONNECTION”
POWER CONNECTION AT HOOD
BOX MARKED “120 VAC INPUT”
120 Volt 60Hz
CONNECT:
- 9 -