CONNECT DUCTWORK
1.Use 8" round metal duct to connect the discharge collar on the hood to the ductwork above.
2.Use duct tape to make all joints secure and air tight.
3.Remove the temporary retaining screw from the lower flue and set it in place on the hood.
4.Secure decorative flue to hood with two mounting screws (3.9x9.5mm).
LOWER FLUE
RETAINING
SCREW
8” ROUND METAL
DUCT
MOUNTING
SCREWS
(3.9X9.5MM)
MAINTENANCE
Proper maintenance of the Range Hood will assure proper performance of the unit.
Grease Filters
The grease filters should be cleaned fre- quently. Use a warm detergent solution. Grease filters are dishwasher safe.
To take off the grease filters: at the handle, push the stop inwards and pull the filters downwards.
Hood Cleaning
GREASE FILTERS
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its fine appearance.
Cleaning tips:
OHot water with soap or detergent is all that is usually needed.
OFollow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
OFor discolorations or deposits that persist, use a
OFor stubborn cases, use a plastic scouring pad or soft bristle brush together with cleaser and water. Rub lightly in direction of polishing lines or "grain" of the stainless finish. Avoid using too much pressure which may mar the surface.
ODO NOT allow deposits to remain for long periods of time.
ODO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface causing rust.
ODO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel for extended periods. Many of these com- pounds contain chemicals which may be harmful. Rinse with water after expo- sure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
- 10 -