4. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table below to find the right liner model number according to the width of the custom hood nominal width. To view specific model information, including depths for each liner models, visit www.broan.ca or contact Technical Support (phone number listed on front cover).
To install, see instruction packed with custom hood | LINER MODEL | CUSTOM HOOD | |
liner. | NOMINAL WIDTH | ||
| |||
NOTE: The liner must be installed before the insert. | L6230SSS | 30” | |
L6230SSS | 36” | ||
| |||
| L6230SSS | 42” |
HA0067A |
5. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the custom hood, using the dimensions shown at right.
NOTE: Keep in mind that the unit exterior flange is 3/4’’.
13³/8” |
26¾” |
HD0340A |
6. REMOVE FILTER
Rest the power pack on a table. Remove tape on filters. Lift filters from power pack by pushing them towards the back and rotate, then set filters aside.
HD0366 |
7. UNPLUG THE BLOWER(S)
Unplug the blower(s) (one or two, depending on model) from the front panel.
HE01105
- 6 -