14. INSTALL THE POWER PACK
CAUTION
Take care not to kink ducting or pinch electrical cable when installing the power pack.
Lift the power pack in custom hood until the bottom of the clasping springs (2 per side) rests on the top of the custom hood base (grey zone in illustration at right).
From inside the power pack, using provided no.
VERTICAL EXHAUST INSTALLATION ONLY
Make sure the adapter/damper enters the ducting and the damper opens freely. Wherever it is possible, seal connections with metal foil duct tape.
CLASPING |
SPRINGS |
HD0370 |
HH0126 |
15. INSTALL THE ADAPTER/DAMPER ON BACK OF POWER PACK
(SINGLE BLOWER MODEL, HORIZONTAL DISCHARGE ONLY)
From the outside of the wall, using two no. 8 x 3/8’’ screws provided in parts bag, secure the adapter/damper to the back of the power pack. Remove tape from damper flap. Connect ducting to the adapter/damper and seal the joint using metal foil duct tape.
|
| WALL |
HH0127A | BACK VIEW | SIDE VIEW |
- 9 -