8. REMOVE WIRING COVER AND FRONT PANEL
Using a Robertson or a Phillips no. 2 screwdriver, remove both wiring cover retaining screws (A). Detach it from the power pack and set aside with its screws. Then, remove both sides screws (B) retaining the front panel to the power pack. Carefully detach the front panel from the power pack and set aside with its screws.
B | A |
| |
HD0365 |
|
9. REMOVE THE ELECTRICAL KNOCKOUT
From inside the power pack, punch out the electrical knockout hole on top left side (C) OR on back left side (D). Install the wire clamp (included in parts bag).
C |
D |
HR0030 |
10. REMOVE THE KNOCK-OUT OPENING (SINGLE BLOWER MODEL ONLY)
Remove the knockout opening on top (vertical discharge installation) or on back (horizontal discharge installation) of the power pack.
1 | 2 |
HR0037 |
|
11. INSTALL THE ADAPTER/DAMPER (SINGLE BLOWER MODEL ONLY)
VERTICAL DISCHARGE INSTALLATION
Using 2 no. 8 x 3/8’’ screws provided in parts bag, secure the adapter/damper to the top of the power pack. Remove tape from damper flap. Seal the adapter to the power pack using metal foil duct tape.
HORIZONTAL DISCHARGE INSTALLATION
HO0137 |
The adapter/damper will be installed on the back of the power pack once the power pack will be mounted in the custom hood. Refer to step 15.
- 7 -