Broan warranty Prepare The Hood, ALLURE QSE1 SERIES RANGE HOOD, Page

ALLURE® QSE1 SERIES RANGE HOOD

PREPARE THE HOOD

DAMPER/DUCT

CONNECTOR

3Remove Damper/Duct Connector from inside the hood. Set connector aside - with mounting screws and parts

bag.

Page 3

PREPARE THE HOOD

TOP RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼” x 10”

Vertical Discharge)

REAR

RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼” x 10” Horizontal Discharge)

6 Remove appropriate Duct Knockout(s) from top or back of hood.

WIRING

COVER

4Remove Wiring Cover from inside the hood. Set cover and mounting screw aside.

ELECTRICAL

CABLE CLAMP

5Remove either top or back wiring knockout and install ap- proved Electrical Cable Clamp.

TAPE	TOP/BACK
UP TO 1”	EDGE
SIDE-TO-SIDE
ADJUSTMENT

PIVOT	DAMPER/DUCT
	CONNECTOR
	(Vertical discharge
	position shown)

7 3¼” x 10” Ducted Discharge Only: Attach Damper/Duct Connector over knockout opening. Make sure damper Pivot is nearest to Top/Back Edge of hood. Remove Tape from

damper flap.

NOTE Damper/Duct Connector can be installed up to 1-inch on either side of hood center to accomodate off-center ductwork. In extreme off-center installations, one end of the duct connector may need to be trimmed to clear

the electrical cable clamp.