OPERATION
Controls
The hood is operated using the slide controls under the bottom of the hood.
The light switch turns the lamps on and off. The blower switch: makes it possible to select the motor operating speed.
Position 0: motor off.
The pilot lamp lights up whenever the blower is on.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1)If blower is OFF - it turns blower ON to HIGH speed.
2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.
LIGHT |
| BLOWER | ||||||
| SWITCH | |||||||
SWITCH | PILOT | |||||||
|
|
|
|
| ||||
|
|
|
|
|
|
| ||
|
| LAMP |
|
|
|
|
| |
0 | 1 |
| 0 | 1 | 2 | 3 | 4 | |
|
|
|
|
|
|
| fig.14 | |
LIGHT BULBS
This range hood requires two light bulbs (included); max 40W, 120V, E12, Type B or Type T8 bulb.
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.
To change bulbs:
1.Remove the screw securing the light fitting.
2.Pull down lens to remove.
3.Replace with light bulbs of the same type.
CAUTION: BULB MAY BE HOT!
fig.15 |
fig.16
10
