Broan warranty Prepare The Hood, CABINET FRONT 3/4, Cabinet, Bottom, AP1 & RP SERIES, Page

AP1 & RP SERIES

2	Use the proper diagram below, for placement of ductwork
	and electrical cutout in cabinet or wall. For a non-ducted
	installation, DO NOT cut a duct access hole.

				3¼” X 10”
HOOD MOUNTING SCREWS (4)				VERTICAL DUCTING
1315/16" (30" hood)			1315/16" (30" hood)
1615/16" (36" hood)			1615/16" (36" hood)
CABINET FRONT
	CABINET		71/2"		11/2"
67/8"
	BOTTOM
105/8"		6¼"	6¼"	97/8"	9"
		VERTICAL DUCT
		ACCESS HOLE
WOOD SHIMS				ELECTRICAL
		CENTER		ACCESS HOLE
(recessed-bottom				(in cabinet bottom)
		LINE
cabinets only)

WOOD SHIMS		3¼” X 10”
(recessed-bottom		HORIZONTAL DUCTING
cabinets only)
	CABINET FRONT 3/4"

1/8"

37/8"	HORIZONTAL DUCT
	ACCESS HOLE
CABINET	6¼"	6¼"
BOTTOM

	1315/16" (30" hood)				71/2"
				1315/16" (30" hood)
	1615/16" (36" hood)
				1615/16" (36" hood)
HOOD
					ELECTRICAL
MOUNTING		CENTER
SCREWS (4)					ACCESS HOLE
			LINE
						(in wall)

Page 3

PREPARE THE HOOD

BOTTOM

COVER

ALUMINUM

FILTERS

WIRING

COVER

3Remove the Aluminum Filters, Bottom Cover, and

Wiring Cover from the hood.

VERTICAL DISCHARGE POSITION
	BLOWER
	MOUNTING
	ROD (2)
BLOWER
KNURLED NUT (2)
HORIZONTAL DISCHARGE POSITION	BLOWER
	MOUNTING
	ROD (2)
BLOWER
KNURLED NUT (2)

4 Blower is shipped in Vertical Discharge Position.

To change blower to Horizontal Discharge Position:

Remove Knurled Nuts from Blower Mounting Rods. Disengage mounting rods from blower and rotate blower to horizontal discharge position. Re-engage mounting rods and tighten blower in place with knurled nuts.