Broan RP Install The Hood, Connect The Wiring, Complete Installation, Install Light Bulbs, Page

AP1 & RP SERIES

DAMPER /

DUCT

CONNECTOR

VERTICAL DUCT

KNOCKOUT

HORIZONTAL DUCT

KNOCKOUT

5 Remove Vertical Duct Knockout or Horizontal Duct Knockout and attach Damper / Duct Connector with

two (2) screws (supplied).

INSTALL THE HOOD

WARNING

To reduce the risk of electrical shock, switch power off at service panel. Lock or tag service panel to prevent

power from being switched on accidentally.

MOUNTING	HOUSE
SCREWS (4)	POWER
	CABLE
	DUCTWORK

6	Run House Power Cable between service panel and
	hood location. Attach power cable to hood using appropri-
	ate connector.
7	Hold the hood in position under the cabinet. Make sure
	the damper / duct connector enters the Ductwork and
	that the damper opens and closes freely.
8	Tighten the four (4) Mounting Screws completely to se-
	cure the hood to the cabinet.

Page 4

CONNECT THE WIRING

GREEN

GROUND

SCREW

HOUSE

POWER

CABLE

HE0059

9 Connect House Power Cable to range hood wiring - BLACK to BLACK, WHITE to WHITE, and GREEN or

BARE WIRE to GREEN Ground Screw.

COMPLETE INSTALLATION

10 Re-install the wiring cover, bottom cover, and filters that were removed in Step 3.

INSTALL LIGHT BULBS

(1) PUSH IN

(2) ROTATE

CLOCKWISE

11 Install Halogen Bulbs. Use 120 V, 50 W, shielded halo- gen bulbs - MR16 or PAR16 with GU10 base. Purchase bulbs separately.