4. Use the chassis
5.Use the ip address command to set the Ethernet IP address for the MMs.
If you are going to use an IPv4 IP address, enter the IP address in dotted decimal notation. You should also disable DHCP and enter a gateway address as well.
When you have assigned the IP and gateway addresses to management interface 1/1, you should also assgin IP and gateway addresses to management interface 1/2 if you have installed a second MM.
switch(config)# interface Management 1/1
If you are going to use an IPv6 address, enter the network information in
switch(config)# interface Management 1/1
6. To display the configuration, use the show
switch# show
no ip address dhcp
ip address 10.24.85.81/20
ip
ipv6 address fd00:60:69bc:832:e61f:13ff:fe67:4b94/64 no ipv6 address autoconfig
!
Logging off the serial console port and disconnecting the serial cable
You can use the serial port to monitor error messages through the serial connection. If the serial port is no longer required, use the logout command to log out of the serial console, remove the serial cable, and replace the protective plug in the serial port.
Establishing an Ethernet connection to the Brocade VDX 8770-4
After using a serial connection to configure the IP addresses for the Brocade VDX
NOTE
Connecting the MMs to a private network is recommended.
By establishing an Ethernet connection, you can complete the Brocade VDX
NOTE
To protect the Ethernet port from damage, keep the cover on the port when not in use.
24 of 32 | Brocade VDX |
| Publication Number: |
