Brocade ICX 6650 Layer 3 Routing Configuration Guide 117
53-1002603-01
Displaying IP configuration information and statistics
When you specify how many seconds’ worth of statistics you want to display, the software selects
the sample that most closely matches the number of seconds you specified. In this example,
statistics are requested for the previous two seconds. The closest sample available is actually for
the previous 1 second plus 80 milliseconds.
Syntax: show process cpu [num]
The num parameter specifies the number of seconds and can be from 1 through 900. If you use
this parameter, the command lists the usage statistics only for the specified number of seconds. If
you do not use this parameter, the command lists the usage statistics for the previous one-second,
one-minute, five-minute, and fifteen-minute intervals.
Displaying IP interface information
To display IP interface information, enter the following command at any CLI level.
Syntax: show ip interface [ethernet stack-unit/slotnum/portnum] | [loopback num] |[tunnel num]
| [ve num]
This display shows the following information.
TABLE 17 CLI display of interface IP configuration information
Field Description
Interface The type and the slot and port number of the interface.
IP-Address The IP address of the interface.
NOTE: If an “s” is listed following the address, this is a secondary address. When the address
was configured, the interface already had an IP address in the same subnet, so the
software required the “secondary” option before the software could add the interface.
OK? Whether the IP address has been configured on the interface.
Method Whether the IP address has been saved in NVRAM. If you have set the IP address for the
interface in the CLI, but have not saved the configuration, the entry for the interface in the
Method field is “manual”.
Status The link status of the interface. If you have disabled the interface with the disable command,
the entry in the Status field will be “administratively down”. Otherwise, the entry in the Status
field will be either “up” or “down”.
Protocol Whether the interface can provide two-way communication. If the IP address is configured, and
the link status of the interface is up, the entry in the protocol field will be “up”. Otherwise the
entry in the protocol field will be “down”.
Brocade# show ip interface
Interface IP-Address OK? Method Status Protocol
Ethernet 1/1/1 10.95.6.173 YES NVRAM up up
Ethernet 1/1/2 10.3.3.3 YES manual up up
Loopback 1 10.2.3.4 YES NVRAM down down