Brocade ICX 6650 Layer 3 Routing Configuration Guide 471
53-1002603-01
enabling multicast routing on GRE tunnels, 106
GRE packet, 95
multicast routing over GRE tunnels, 97
point-to-point GRE tunnels, 95
IPv6
advertising address summaries, 160
clearing RIPng routes, 163
clearing tunnel statistics, 405
configuring a manual tunnel, 404
displaying ECMP load-sharing information, 409
displaying interface-level settings, 406
displaying tunnel information, 405
ECMP load sharing, 408
static route parameters, 402
IPv6 over IPv4 tunnels, 403
ipv6 rip summary-address, 160
L
Layer 2
enabling or disabling, 139
Layer 2 switch
basic IP parameters and defaults, 17
configuring IP parameters, 88
displaying IP information, 128
interface IP parameters, 19
IP global parameters, 17
Layer 3
modifying and displaying parameter limits, 134
Layer 3 switch
basic IP parameters and defaults, 11
configuring a default network route, 54
configuring to drop IP packets, 49
IP global parameters, 11
IP interface parameters, 15
load balancing, configuring using multiple static routes, 49
log messages for DHCP, 87
M
management IP address
configuring and specifying the default gateway, 88
Maximum Transmision Unit (MTU)
changing, 28
changing on an individual port, 30
path discovery (RFC 1191) support, 30
Maximum Transmission Unit (MTU)
globally changing, 29
MTU
changing the value for a tunnel interface, 104
configuring path discovery, 105
path discovery, 96
multicast protocols
displaying information, 110
N
network routes
configuring default, 54
O
Open Shortest Path First (OSPF)
differences between version 2 and version 3, 228
overview, 168
point-to-point links, 169
OSPF
assigning a totally stubby area, 180
assigning an area range, 183
assigning areas, 179
assigning interfaces to an area, 184
assigning virtual links, 189
auth-change-wait-time, 185
authentication-key, 185
block flooding of outbound LSAs, 187
changing administrative distance, 207
changing the reference bandwidth, 194
changing the reference bandwidth for the cost, 192
changing the timer for authentication changes, 186
clearing information, 212
clearing information for areas, 213
clearing redistributed routes from the routing table,
213
clearing topology information, 213
CLI commands, 214
configirng group Link State Advertisement (LSA)
pacing, 208
configuration, 177
configuring a non-broadcast interface, 188
configuring a point-to-point link, 211
configuring default route origination, 205
configuring external route summarization, 204
configuring graceful restart, 211
cost, 185
dead-interval, 185
defining redistribution filters, 194
designated router election in multi-access networks,
170