Figure 11
Removing Rotisserie Burners and Rotisserie Burner Orifices (Figure 12)
1.Turn OFF gas supply to grill.
2.All grill parts must be cool before attempting to clean.
3.Remove (1) screw from each rotisserie burner electrode.
4.Pull forward on the electrode to expose approximately 3 inches of the electrode wire.
5.If you are replacing the electrode, remove the electrode wire from the electrode. Do not allow the electrode wire to slip back into the access hole.
6.If you are not replacing the electrode, allow the electrode to lay on the cooking surface.
7.Remove (6) screws from the brackets for the elevated cooking racks. The brackets are located at each end (2 brackets) and between (1 bracket) the rotisserie burners.
8.At the center of the gas grill, grasp the end of rotisserie burner, pull forward and slide the opposite end of the rotisserie burner from the orifice fitting.
9.Apply air pressure into the face and end of the rotisserie burner to remove spiders, spider webs, dust, lint and debris. A flexible, soft bristle, bottle brush can be used to clean the interior of the rotisserie burner.
10.Remove the rotisserie burner orifice from the orifice fitting.
11.Apply air pressure into the rotisserie burner orifice and orifice fitting to remove spiders, spider webs, dust, lint and debris. A flexible, soft bristle, bottle brush can be used to clean the orifice fitting.
12.To reinstall components, reverse above procedure starting with Step 10.
Figure 12
Cleaning the Orifices
No regular maintenance should be needed for the orifices. They should only be removed if it is determined that there is a blockage.
Warning: Serious injury may occur if the orifice is not located properly in the orifice fitting when reassembled.
Removing and Replacing the Piezo Ignitors and Electrodes
1.Remove all gas control knobs and ignitor knobs.
2.Remove chip tray.
3.Remove valve cover (7 screws).
4.Piezo ignitors are located at rear of valve cover.
5.Remove (1) screw for each electrode.
6.Remove (2) screws for each piezo ignitor.
7.Reverse above procedure to replace components.
Page 11 |
