Brother 1240 manual

UNINET IMAGING INC. • BROTHER 1240/1650 • DISASSEMBLING THE TONER CARTRIDGE

1.With the use of small flat blade screwdriver, slightly pry up the white plastic alignment hub located from the non-gear side of the developer roller and remove it.

2.NOTE: Be aware of the pressure spring behind the white plastic hub and do not lose it.

3.On the same side and with the help of a small jeweler screwdriver release the three (3) clips holding the developer roller bearing cap to the toner hopper. The first clip is right below the screw holding the developer blade, the opposite clip is between the side of the roll and the casing while the third one is accessi- ble from outside the casing.

www.uninetimaging.com

USA

Ph: +1-310-280-9620

Fx: +1-310-838-7294

EUROPE

+34-93-757-1335

+34-93-741-4166

JAPAN +81-3-44-55-2789 +1-310-838-7294

BRAZIL +55-11-4822-3033 +55-11-4822-3353

ARGENTINA +54-11-4571-2388 +54-11-4574-3706

11124 Washington Blvd., Culver City, California U.S.A. 90232 Ph: 310 280-9620 • Fx: 310 838-7294 • sales@uninetimaging.com

© 2005 Uninet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. Uninet Imaging does not guarantee or warrant downloaded information.