|
| Troubleshooting | ||
|
|
|
| |
Error Message | Cause | Action |
|
|
Cover is Open | The front cover is not completely | Close the front cover of the machine. |
|
|
| closed. |
|
|
|
Cover is Open | The ADF cover is not completely | Close the ADF cover of the machine. |
|
|
| closed. |
|
|
|
| The ADF is open while loading a | Close the ADF cover of the machine, then |
|
|
| document. | press Stop/Exit. |
| |
Cover is Open | The fuser cover is not completely | Close the fuser cover of the machine. |
|
|
| closed or paper was jammed in | Make sure paper is not jammed inside |
|
|
| the back of the machine when |
| ||
| the back of the machine, and then close |
|
| |
| you turned on the power. |
| ||
| the fuser cover and press Start. |
|
| |
|
|
| ||
|
|
|
| |
Disconnected | The other person or other | Try to send or receive again. |
|
|
| person’s fax machine stopped the |
|
|
|
| call. |
|
|
|
|
|
|
| |
Document Jam | The document was not inserted |
|
| |
| or fed properly, or the document |
| ||
| scanned from the ADF was too |
| ||
| long. |
|
|
|
|
|
|
| |
DR Mode in Use | The machine is set to Distinctive | Set Distinctive Ring to Off. (See Turning off |
|
|
| Ring mode. You cannot change |
| ||
| the Receive Mode from Manual to |
|
|
|
| another mode. |
|
|
|
|
|
|
| |
Drum Error | The corona wire on the drum unit | Clean the corona wire on the drum unit. |
|
|
| needs to be cleaned. | (See Cleaning the corona wire on page 62.) |
| |
Drum Stop | It is time to replace the drum unit. | Replace the drum unit. (See Replacing the |
|
|
|
|
| ||
Duplex Disabled | The duplex tray is removed or is | Carefully put the duplex tray into the |
|
|
| not properly installed. | machine until it clicks into place. |
| |
| The back of the machine is not | Close the back cover of the machine. |
|
|
| closed completely. |
|
|
|
|
|
|
| |
EL Error | The machine has a mechanical | Open the front cover and close it again. |
| B |
| problem. |
|
| |
|
|
|
| |
Fuser Error | The temperature of the fuser unit | (For |
|
|
| does not rise to a specified | Received fax messages still in memory will |
| |
| temperature within the specified | be lost when the machine is turned off. See |
| |
| time. |
| ||
| The fuser unit is too hot. | report on page 73 before disconnecting the |
|
|
| machine so you will not lose any important |
|
| |
|
|
| ||
|
| messages. Then, turn the power switch off, |
| |
|
| wait a few seconds, and then turn it on |
| |
|
| again. Leave the machine for 15 minutes |
| |
|
| with the power on. |
| |
|
| (For |
| |
|
| Turn the power switch off, wait a few |
| |
|
| seconds, and then turn it on again. Leave |
| |
|
| the machine for 15 minutes with the power |
| |
|
| on. |
| |
|
|
|
|
|
|
| 69 |
| |
|
|
| ||
|
|
|
|
|