BE-1204B-BC • BE-1206B-BC 9-3
Chapter 9 Error code list
Code Error Messages Error Measures
E-13
Performing the home
position detection for
the hoop position
adjustment
This is displayed in case that the
machine had been shut down
while the hoop was moving and
now is started up in a mode
without the home position
detection, or in case that the
machine is started up in a mode
without the home position
detection after pressing the CAP
SW to change the hoop.
Press the to start the home position moving.
E-14 Y-axis home position
error Y-axis home position error
Turn the power off and on once. If the same
error occurs again, the Y-axis mechanism is
faulty.
E-15 Press for restart.
Stop error during SSP processing
(when pressing the stop key while
the hoop is moving)
Hoop movement restarts if you press .
E-16 Needle bar No. of the
destination is abnormal
Needle bar No. of the destination
is out of range
Press the , or turn ON the F/B switch on the
head to either side to cancel the error and set up
the needle bar setting again.
E-17 Speed range abnormal Speed range is out of range This is not usually displayed.
E-18 X-axis stepping motor
connector error
X-axis stepping motor connector
error
Turn the power off and on once after checking to
see that the connector of the X-axis stepping
motor is properly connected.
E-1A ERROR 1A Destination coordinates error
E-1B ERROR 1B The machine has reached the
mending stop position.
This is not usually displayed.
E-1C Restart perimeter The machine stops during mask
tracing.
Tracing is cancelled if the ke y is pressed
when the machine is stopped during mask
tracing. Press the key to continue
tracing.
E-1D Stop while transferring
to next repeat pattern
The machine stops while the
needle is moving between patterns
during repeat sewing.
This is displayed when the stop switch is pressed
while the hoop is moving. Press the to
move the hoop again. (It is necessary to press
the again to start sewing.)
Errors E-1C and E-1D are not displayed due to mechanical problems.
E-1E
Remove unused
presser foot, or it may
be damaged
When the power is turned on, bed
can not be retracted.
E-1F Presser foot down error
Presser foot down error while
searching for home position just
after the power is turned on.
This is not displayed in this model.
E-21 Area over Hoop overhang (+X)
E-22 Area over Hoop overhang (+Y)
E-23 Area over Hoop overhang (+X, +Y)
E-24 Area over Hoop overhang (-X)
E-25 Area over Hoop overhang (+X, -X)
E-26 Area over Hoop overhang (-X, +Y)
E-27 Area over Hoop overhang (+X, -X, +Y)
E-28 Area over Hoop overhang (-Y)
E-29 Area over Hoop overhang (+X, -Y)
Pattern or the needle position is out of the
embroidering area. Reset the embroidering
area on the panel or move the hoop to the
sewable position.