the right side (see arrow b) until the cover clicks into place.
•Replace the cover so that the end of the thread comes out from the left side of the cover (as shown by the line in the diagram).
■For models equipped with the quick-set bobbin
aRaise the needle to its highest position by turning the handwheel toward you (counterclockwise) or press (needle position button) (for models equipped with the needle position button), and raise the presser foot lever.
bSlide the button and open the cover. 1 2
aCover
bSlide button
cPut the bobbin in, feed the end of the thread through the slit, and then pull the thread to cut it.
•Only use bobbins that were designed to be used with this machine.
CAUTION
●Make sure you set the bobbin so the thread unrolls in the right direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle.
1
aCutter
•Make sure that the thread is correctly inserted through the
1
1
a
Memo
●The order that the bobbin thread should be passed through the bobbin case is indicated by marks around the bobbin case. Be sure to thread the machine as indicated.
dReplace the bobbin cover. Put the left tab in place (see arrow a), and then press lightly on the right side (see arrow b) until the cover clicks into place.
Memo
●You can begin sewing immediately without drawing up the bobbin thread. If you want to draw up the bobbin thread before you start to sew, follow to the procedure in “Drawing up the lower thread” (page 19).
15