Setting Up the Machine
10
STEP 1
The LCD shows:
Preparing System
Approx 4 Minutes
Cleaning
Please Wait
Caution
• DO NOT take out ink cartridges if you do not need
to replace them. If you do so, it may reduce the ink
quantity and the machine will not know the
quantity of ink left in the cartridge.
• DO NOT shake the ink cartridges. If ink stains your
skin or clothing, wash with soap or detergent at
once.
• DO NOT repeatedly insert and remove the
cartridges. If you do so, ink may seep out of the
cartridge.
• If you mix the colours by installing an ink cartridge
in the wrong position, clean the print head several
times after correcting the cartridge installation.
(See Cleaning the print head in Appendix B of the
User’s Guide.)
• Once you open an ink cartridge, install it in the
machine and use it up within six months of
installation. Use unopened ink cartridges by the
expiration date written on the cartridge package.
• DO NOT dismantle or tamper with the ink
cartridge, this can cause the ink to leak out of the
cartridge.
• Brother multifunction machines are designed to
work with ink of a particular specification and will
work to a level of optimum performance when
used with genuine Brother branded ink cartridges.
Brother cannot guarantee this optimum
performance if ink or ink cartridges of other
specifications are used. Brother does not
therefore recommend the use of cartridges other
than genuine Brother branded cartridges with this
machine or the refilling of empty cartridges with ink
from other sources. If damage is caused to the
print head or other parts of this machine as a result
of using incompatible products with this machine,
any repairs required as a result may not be
covered by the warranty.
7 Print quality check
1After the cleaning cycle is finished, the LCD
shows:
Set Paper and
Press Start
2Make sure paper is loaded in the paper tray.
Press Colour Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3Check the quality of the four colour blocks on
the sheet.
(black/ yellow/ cyan/ magenta)
Improper Setup
Avoid touching the printed surface of the
paper immediately after printing, the surface
may not be completely dry and may stain your
fingers.
4The LCD shows:
Is Quality OK?
1.Yes 2.No
5Do one of the following:
If all lines are clear and visible, press 1
(Yes) on the dial pad to finish the quality
check.
If you can see missing short lines, press 2
(No) on the dial pad and go to step 6.
OK Poor