Attaching the Embroidery Frame 157

4

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Attaching the Embroidery Frame
This section describes how to attach the embroidery frame.

Attaching the embroidery

frame

aWind the embroidery bobbin thread onto the
bobbin and set it into the bobbin case.
• For details, refer to “Winding/Installing the
Bobbin” (page 25).
bRaise the presser foot lever.
aPresser foot lever
cPass the embroidery frame under the presser
foot while raising the presser foot lever even
further.
CAUTION
dWhile lightly holding the lever on the frame
holder to the left, align the two pins on the
embroidery frame holder with the mounting
brackets on the frame, and then press the
frame into the embroidery frame holder until a
click is heard.
After pressing the front mounting bracket onto
the pin so that it clicks into place, press the
back mounting bracket into place.
aLever
aMounting brackets
bPins
Note
zBe sure to insert both pins. If only the
forward or the back pin is inserted, the
pattern may not turn out correctly.
CAUTION

●Do not hit the needle with your finger or

the embroidery frame. It may cause injury

or needle breakage.

a

●Correctly set the embroidery frame into

the embroidery frame holder. Otherwise,

the presser foot may hit the embroidery

frame, resulting in injury.

1
1
2
1
2
3