Brother PE-600II operation manual 192, ARemove the bobbin

APPENDIX —————————————————————————————————————————————————————

0The bobbin will stop rotating automatically when it is done winding, and the bobbin holder will return to its original position.

aRemove the bobbin.

Note

●When removing the bobbin, do not pull on the bobbin winder seat. Doing so could loosen or remove the bobbin winder seat, resulting in damage to the bobbin winder.

bPull the thread through the guide slit in the bobbin winder seat to cut the thread with the cutter.

CAUTION

●Check that the bobbin thread has been wound correctly, otherwise the needle may break or the thread tension will be incorrect.

●Be sure to clean the bobbin case each time that the bobbin is changed. Thread wax and dust easily collect around the hole in the tension-adjusting spring on the bobbin case, resulting in an incorrect thread tension. For details, refer to “Cleaning the bobbin case” on page 195.

●Be sure to check the tension of the bobbin thread each time that the bobbin is changed.

●Depending on the bobbin thread type, the tension of the bobbin thread may differ. Be sure to check the tension of the bobbin thread and adjust the tension if necessary.

For a metal bobbin, use both weights, large (L) and small (S).

For detailed instructions on how to adjust the bobbin tension, refer to page 85.

1

2

1Weight (L) (Parts Code: XC5974-151)

2 Weight (S) (Parts Code: XC6631-051)

■If bobbin winding is stopped before it is finished: The bobbin winder stops automatically if the thread does not feed, for example, if it becomes tangled on the spool pin. If this occurs, correctly thread the bobbin winder, and then wind the bobbin correctly.

192