Brother PE-600II operation manual Using the Settings Key, Understanding the settings screen, 140

BASIC SETTINGS AND HELP FEATURE —————————————————————————————————————————

Using the Settings Key

Touch (settings key) to change many of the basic embroidery machine settings.

Understanding the settings screen

There are five pages in the settings screen. Touch		and	in the lower-right corner of the screen until
the desired page is displayed. The	key appears on all pages.
■ Page 1		■ Page 2

	6 CHANGING THE THREAD COLOR DISPLAY
1 Touch to quit specifying settings. The settings are	The color information in the thread color
	sequence display and the needle bar thread
confirmed and the screen that was displayed
	information can be switched to the color name,
before the settings key was touched appears
	the thread color number or the sewing time, refer
again.
	to page 145.
2 The guides (embroidery frame size, centerpoint
	7 DISPLAY EXPANDED THREAD COLOR
marker, grid and cursor) for the pattern display
	The thread colors displayed in the thread color
area can be specified.
	sequence display and in the needle bar thread
3 The TOTAL COUNT counter shows the total
	information can be displayed as a color from the
number of stitches, and the TRIP COUNT counter
	machine's built-in color thread table, as a thread
show the number of stitches that have been sewn
	color from another manufacturer, or as a color
since the machine's last maintenance.
	that is created with PE-Design ver. 5.0 as an
4 The TOTAL TIME counter shows the total amount
	original color chart.
of time that the machine has been used, and the
	If “ON” is selected, choose from the following
TRIP TIME counter shows the amount of time that
	three threads, refer to page 146.
the machine has been used since its last
	Original Thread
maintenance.
	Custom Thread 1
Use counters 3 and 4 as a standard for performing
	Custom Thread 2
periodic maintenance and for receiving maintenance
	8 THREAD TRIMMING/“DST“ SETTING
for the machine.
	Specifies whether or not jumpstitches are cut. In
5 VERSION
	addition, when using Tajima embroidery data
Shows the version of the software installed on this
	(.dst), you can specify whether or not the thread is
embroidery machine
	cut according to the specified number of jump
	codes. (Refer to page 149.)
	9 SHORT STITCH DELETE
Note	Specifies the pitch length of short stitches that are
● Check with your local authorized Brother	to be deleted, refer to page 150.
	0 THREAD TAIL
dealer or at www.brother.com for details on	Specifies the length of upper thread that remains
available updates.	threaded through the needle after the thread is
	trimmed (length of thread passed through the eye
	of the needle), refer to page 150.

140