Page 45
Cleaning the Platen Roller
Dirt and debris on the platen roller can make the roller feed paper into the printer at an
angle, degrade the quality of the printed image, or both.
1. Make sure the printer is powered on without paper loaded.
NOTE: If paper is loaded and detected by the printer when you attempt
to initiate Cleaning Mode, a Form Feed will be executed instead.
2. Press the main switch for about two seconds. The “Data” LED will
illuminate.
3. Press the main switch again for less than 2 seconds. The feed motor will
begin to turn.
4. Insert the black cleaning cloth that came with the printer into the
printer’s paper input slot with the rough black side, which contains the
cleaning material, towards the front of the printer. See Figure 18. The
printer pulls the Cleaning Cloth through.
5. The roller movement will stop automatically after about 60 seconds, and
the printer returns to an idle state. If you press the main switch before
60 seconds has elapsed, this will toggle the feed motor on and off.
Pressing the main switch twice quickly will shut off the printer.