![](/images/new-backgrounds/1040827/4082719x1.webp)
Changing Needles and Light Bulb
Note
Please make sure power is off before carrying out the following operations. There is a chance of injury if the machine accidentally starts running during this operation.
Changing the Feed Pin
1Set the feed dogs to “vel-
vet” position. (see Page 5)
2Remove needle, presser
foot and needle plate.
Note | CONTENTS |
| |
Please make sure power is off before carrying out |
|
the following operation. The glass plate over the | Accessories |
had a chance to cool down before changing bulbs. | |
light bulb will be hot immediately after using the |
|
machine, so you should wait until the machine has |
|
Changing the Needle
1Turn the sewing ma- chine off. Raise needle
to highest position us- ing hand wheel, and lower presser foot.
2Loosen screw with screwdriver, and re- move needle.
3Hold the needle with the flat side to the right, and insert the needle as far as it will go. Make sure needle is screwed in tightly.
Screwdriver
3Lower presser foot and turn hand wheel until feed
pin is in its highest position.
4Insert small screwdriver (in- cluded) as shown in diagram.
5While holding spring with fingertip, lower the feed pin changer onto the needle to pick it up.
Names of
Parts
Changing Light Bulbs |
| Before You Begin | |||
1 Turn off power. | Screwdriver | ||||
2 Remove screw from | |||||
| |||||
|
|
|
| ||
head. |
| Light Bulb | Needles and | Changing | |
|
| ||||
3 Remove bulb housing. |
|
| Threading |
| |
|
|
|
| ||
|
| Needle Chart | Samples and | Stitch | |
|
| Presser |
|
The needle should lay parallel to a surface.
Changing Feet |
✽ Check needles on a flat surface to make sure they’re not bent.
Flat surface
6 Attach new feed pin to |
feed pin changer, lower |
4Unscrew bulb and re- move.
230V 120V
Sewing | Basic |
Lay needle on a flat surface (such as the needle plate or a plate
of glass).
Note
HLX5 needles should be uses; however, Schmetz 130/ 705H may also be used under normal circumstances.
and attach while holding |
spring with fingertip.
7Remove screwdriver.
8
5Screw in new bulb.
Sewing Light:
See page 19.
6
Light
Light
Bulb Bulb
Caring for Your Machine |
Trouble Shooting |
6