![](/images/new-backgrounds/1040827/4082723x1.webp)
Bobbin Stop
* Place the thread end so that it does not protrude from the bobbin.
6 While holding the end of the thread, step on | 7 Stop winding when bobbin is full. | 8 Manually move bobbin stop back to 9 Cut thread and remove bobbin. |
the foot controller for a few seconds. Once | Take foot off foot controller. | original position. |
enough thread has wound itself around the |
|
|
bobbin to hold itself in place, release the |
|
|
foot controller and trim the excess thread. |
|
|
CONTENTS | |
Accessories | |
Parts | Names |
| of |
Begin | Before You |
Changing Needlesand Light Bulb |
Bobbin Insertion | CAUTION – Moving parts – |
To reduce risk of injury, switch off before servicing. Replace cover.
Latch Spring
Slide Plate
| Thread Notch | |
Bobbin Door | ✽ Bobbin should be | |
positioned so it | ||
| ||
| winds to the left |
1
2
| Threading |
| |
Needle Chart | Samples and | Stitch | |
Presser Feet | Changing | ||
Sewing | Basic | ||
Machine | Your | Caring |
1 Lift slide plate (and open bobbin 2 Put bobbin into the bobbin case. door).
✽ Run thread through thread notch and under latch spring, so that a length of about 10 cm is exposed.
8✽ Use a bobbin case with an idling pre- vention spring.
3Pull the latch lever of the bobbin case out and push the bobbin case into the shuttle race and release the latch lever.
✽If the latch lever is not all the way on the hook, it may fly off during sewing and cause lower thread breakage.
4Lower slide plate and close bobbin door, following numbers 1 2 above in order.
for |
Trouble Shooting |