4 Check that the roll release lever

 

Roll release lever

is in the up position.

Cutter

Printing unit

Thread the end of the DK Roll

 

 

 

into the slot immediately in front

 

 

of the cutter.

 

 

When unable to thread the end of the DK Roll fully into the slot, thread it as far as possible. Lower the roll release lever and close the cover, then press

the Feed button () to set the roll.

5 Push down the roll release lever and close the DK Roll cover.

5 Attaching the paper guide

The printer contains a paper guide which can hold up to 10 individual label sheets.

1 Attach the paper guide to the

Paper guide

front of the printer as shown

 

on the right.

 

You will need to remove the paper guide if you wish to print and cut more than 10 labels at a time.