16
KNOWING YOUR SEWING MACHINE
CONOZCA SU MAQUINA DE COSER

Lower Threading

1. Raise the needle to its highest position by turning
the balance wheel toward you (counterclockwise)
and raise the presser foot lever.
2. Open the shuttle cover behind the extension table
on the front of the machine and remove the
bobbin case by pulling its latch toward you and
pulling it out from the shuttle race toward you (fig.
A).
3. Unwind about 10 cm (4") from a full bobbin and
insert the bobbin into the bobbin case. Pull the
trailing thread into the slot, down and to the left, as
shown in fig. B below, until it enters the delivery
eye under the tension spring.
4. Holding the bobbin case by the latch, fully insert
the bobbin case into the shuttle race and release
the latch. Make sure the metal finger fits into the
notch at the top of the race as shown in fig. C
below.
NOTE:
If the bobbin case is not properly placed back into the
machine, it will fall out from the shuttle immediately
after starting to sew.
1Bobbin case latch
2Bobbin case finger
3Tension spring
4Metal finger
5Notch
Enhebrado inferior
1. Levante la aguja a su posición más alta, girando
la ruedecilla hacia usted (en el sentido contrario
al de las manecillas de un reloj) y levante la
palanca del prensatelas.
2. Abra la tapa del porta accesorios de la mesa
extensible, en la parte delantera de la máquina, y
retire el portacanillas de la máquina, tirando la
uña metálica (pestillo) hacia usted y sacándola
de su alojamiento (fig. A).
3. Tire unos 10 cm (4") de hilo de una canilla llena e
inserte la canilla en su alojamiento. Tire del hilo
suelto y páselo por la hendidura, abajo y hacia la
izquierda, tal como se indica a continuación en la
fig. B, hasta que quepa dentro del ojo de entrega,
debajo del resorte tensor.
4. Sujetando el portacanillas por la uña metálica,
introduzca todo el conjunto en el alojamiento y
suelte el pestillo. Asegúrese de que la uñeta
metálica se encaje en la ranura arriba tal como se
indica en la fig. C a continuación.
NOTA:
Si el portacanillas no se encuentra bien colocado en
la máquina, se saldrá de su alojamiento
inmediatamente después de empezar a coser.
1
Pestillo del portacanillas
2
Uñeta del portacanillas
3
Resorte tensor
4
Uñeta metálica
5
Hendidura
15

A B-1 B-2

C

B-3

12
3
5
4