Rialta
1.Turn off the gas supply at the main tank.
2.Turn the refrigerator’s mode selector to "OFF".
3.Remove the refrigerator’s system cover located on the left front of the refrigerator by removing 5 retaining screws.
4.Remove 5 retaining screws securing the refrig- erator to the enclosure.
5.Remove the drawer directly above the refrigerator.
6.Turn the manual
7.Disconnect the vehicle’s 12 volt DC supply wires from the refrigerator’s terminal block.
8.Disconnect the LP gas supply line from the refrig- erator’s manual shut-off valve. See Figure 12. CAUTION: To prevent gas leaks and damage to
the gas supply lines and fittings, use two wrenches when connect- ing or disconnecting gas fittings.
9.Disconnect the refrigerator’s AC power cord from the wall receptacle.
10.Open the cabinet door to the left of the refrigera- tor. Remove the access panel at the rear of the cabinet. This will allow access to the refrigerator’s
Retaining | Intake Pipe |
| |
Washer |
|
Exhaust Pipe
(Isolated)
Figure 13 - Vent Terminal Housing
11.Remove the phillips head screw and retaining washer which secure the
12.Remove both the intake and exhaust vent piping from the vent terminal housing. Care must be taken not to damage the "O" ring seals when removing the piping.
13.Remove right dinette assembly cover panel to access the refrigerator retaining bracket. Refer- ence "Right Dinette Assembly Cover Panel Re- moval" in the Interior Section.
14.Loosen and remove the refrigerator’s retaining screws at rear base of the refrigerator.
15.Position the flexible
16.To
17.After connecting the vehicle’s gas supply line to the refrigerator’s manual
18.Turn off the gas supply at the manual
19.Apply leak test solution to all gas fittings and verify that there are no leaks. Do not test for gas leaks with an open flame.
21
