On-Air 2000 Executive ~ 3rd Edition ~ 2nd August ’02 ~ 4744

Setting up

Please note that your handset must be registered to the base station before use.

Plan the location

Situate your product close enough to the mains power sockets so that the cable will reach.

Make sure it is at least 1 metre away from other electrical products to avoid interference.

Do not situate the product in the bathroom or other humid areas.

1Plug the power adaptor into the wall socket and switch on

2Charge the battery in the handset for at least 16 hours

WARNING

Under no circumstances should non-rechargeable batteries be used. Only use the approved batteries. Using unapproved batteries will invalidate your guarantee and may damage the telephone.

Fully discharging the batteries at least once a week will help them to last as long as possible. However, the charge capacity of rechargeable batteries will reduce with time as they wear out, so reducing the talk/standby time of the handset. Eventually they will need to be replaced. New batteries can be obtained from the Helpline on 0870 240 4682.

Place the handset into the charger and leave the battery to charge. When the battery has been charged for at least 16 hours the display will show the symbol.

Empty

1/3

2/3

Full

Battery low warning

If the handset battery symbol is empty and you hear warning beeps, you will need to recharge your handset before you can use it.

Battery performance

Your handset is supplied with NiMH batteries. These need to be initially charged continuously for 16 hours to reach full charge.

Note that the battery charge icon does not indicate the correct level when the batteries are first installed. The batteries must first be fully charged.

6

Page 7
Image 7
BT 2000 Executive manual Setting up, Plan the location, Battery low warning, Battery performance