Other Problems | Buffalo Technology WYR-G54 specs

Troubleshooting

If the LEDs indicate that the network is working properly (Power LED is on, Transmit/Receive LED blinks), check the TCP/IP settings of the network.

Changing Client TCP/IP Settings in Windows

Consult the LAN Administrator for TCP/IP settings.

To add or change the TCP/IP Settings:

1.On the Windows task bar click Start.

2.Select Settings, then Control Panel.

3.Double-click on the Network icon to view the Network Properties.

4.From the list of installed components, verify the TCP/IP => wireless LAN adapter protocol is installed.

•If the wireless adapter protocol is not yet installed, click the Add button and select the TCP/IP protocol from the list. Refer to Windows Help for more information.

•If the wireless adapter protocol is installed, select the protocol and click the Properties button. Verify the parameters match the settings provided by your LAN Administrator. Make changes if necessary, and click OK.

5.When or if prompted, restart your computer.

B. 1.3 Other Problems

Please refer to www.buffalotech.com for further reference materials.

48

Image 48

Buffalo Technology WYR-G54 manual Changing Client TCP/IP Settings in Windows, Other Problems

Contents

WYR-G54 Table of Contents Table of Contents Table of Contents AirStation G54 Wireless Cable/DSL Router WYR-G54 Introduction Home Networking SOHO/SMB Networking AirStation WYR-G54 Package Contents System Requirements Product Views About the AirStation CD Introduction Installation / Setup Setup PreparationSetup Overview Introduction Open the Setup Screen Antenna Logging Setup Wizard Launch Internet SetupChoosing a Connection Type DSL users can now skip to Setup Wizard Setup Cable Connection OptionsAutomatic IP Assignment by ISP Setup Wizard Cable Manual Entry of IP InformationCable Users can now skip to Setup Wizard DSL PPoE SetupDSL Connection Options Setup Wizard Line Test Line Test Setup Wizard Security Wireless Security Setup Wireless Settings WEP Setup LAN Settings Wireless Settings Client computers may Roam between the AirStations Choosing Clients that can Access LAN or WAN Resources Wireless Security WEP Setup WAN Port Settings WAN Port Settings Advanced Settings Direct Connection Options PPPoE Client Options Remote Management When Dyanmic DNS Routing Information Address Translation Address Translation NAT Demilitarized Zone Client NAT by Service and Device Network Address Translation Packet Filtering Packet Filtering Intrustion Detector Firewall Intrusion Detector UPnP Service UPnP System Information Basic Settings Basic Settings Advanced Settings Client Monitor Diagnostics Diagnostics Log Information Log InformationIntrustion Detector Logs possible Save or Restore Settings Restore Defaults Restore Factory DefaultsRestart Firmware Update Troubleshooting Common ProblemsStatus LED Lit Red Table B.1.1 Diag LED Activity Table Changing Client TCP/IP Settings in Windows Other Problems Glossary DCE Data Communications Equipment Dsss Direct Sequence Spread Spectrum MHz MegaHertz One million cycles per second PCI Peripheral Component Interconnect a ROM Read Only Memory Permanent memory Glossary Glossary FCC / CE Information Federal Communication Commission Interference Statement Important Note Federal Communication Commission Interference Statement FCC RF Radiation Exposure Statement Europe EU Declaration of Conformity FCC / CE Information 1999/5/ΕΚ FCC / CE Information Intended use EU Countries intended for use EU countries not intended for use Warranty Information Contact Information General Inquiries 4030 W. Braker Ln. Suite Austin, Texas Tel Fax