Buffalo Tools GEN3250 Air Filter Maintenance, Spark Plug Maintenance, Emptying the Fuel Tank

Models: GEN3250

1 26
Download 26 pages 29.86 Kb
Page 19
Image 19
Air Filter Maintenance

Air Filter Maintenance

Routine maintenance of the air filter helps maintain proper airflow to the carburetor. Occasionally verify that the air filter is free of excessive dirt. The air filter will require more frequent cleaning when operating this generator in extremely dusty areas.

To clean air filter, remove from generator. Wash in kerosene. Pour motor oil on filter, squeeze out excess oil and reinstall in the generator.

Spark Plug Maintenance

The spark plug is essential for proper engine operation. The spark plug should be intact, free of deposits, and properly gapped. A bad or incorrectly installed spark plug can cause engine damage.

To inspect the spark plug:

1.Remove the spark plug by pulling on the spark plug cap.

2.Unscrew the spark plug from this generator by using the included spark plug wrench.

3.Visually inspect the spark plug. If it is cracked and/or chipped, discard and install a new spark plug. A F6TC spark plug, such as NGK BPR5ES, is recommended.

4.Measure the spark plug electrode gap with a gauge. The gap should be 0.028-0.031in (0.7-0.8mm). (See Figure 9.)

5.If re-using the spark plug, use a wire brush to clean any dirt from around the spark plug base and then re-gap the spark plug.

6.Screw the spark plug back into place on this generator by using the included spark plug wrench.

7.Replace the spark plug cap.

Figure 9 - Measuring the spark plug gap

Emptying the Fuel Tank

To store this generator for extended time, drain the gasoline from the fuel tank.

To drain gasoline from this generator:

1.Turn the fuel valve to the “off” position.

2.Remove the fuel filter cup.

3.Empty the fuel filter cup of any fuel.

4.Place a receptacle underneath this generator to catch gasoline as it drains.

5.Turn the fuel valve to the “on” position and allow all gasoline to drain.

6.Turn the fuel valve to the “off” position.

7.Replace the fuel filter cup.

8.Store the drained gasoline in a suitable place.

To store this generator for extended time, the fuel needs to be drained from the carburetor.

To drain the gasoline from the carburetor turn the fuel valve to the “off” position while the engine is running. The generator will shut down when all the gasoline in the carburetor has been used.

Do not store gasoline for more than 3 months.

Usage: Do not use fuel stabilizers with this generator, doing so could cause damage to the generator, or decrease the fuel and operating efficiency of the generator. You may choose to add a fuel conditioner to oxygenate the fuel and to help it run more efficiently.

GEN3250 3250 Surge Watts/2500 Running Watts Portable Generator

19

Page 19
Image 19
Buffalo Tools GEN3250 Air Filter Maintenance, Spark Plug Maintenance, Emptying the Fuel Tank, Measuring the spark plug gap