Buick 2006 manual Finding a Station, Setting Preset Stations

Finding a Station

BAND: Press this button to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The display will show the selection.

O/ e (Tune): Turn this knob to select radio stations.

tSEEK u: Press the right or the left arrow to go to the next or to the previous station and stay there.

The radio will only seek stations with a strong signal that are in the selected band.

tSCAN u: Press and hold either arrow for

two seconds until FREQUENCY SCAN appears on the display. The radio will go to a station, play for a

few seconds, then go on to the next station. Press either arrow again to stop scanning.

To scan preset stations, press and hold either arrow for four seconds until PRESET SCAN appears on the display. The radio will go to the next preset station, play for a few seconds, then go on to the next preset station. Press either scan arrow again or one of the pushbuttons to stop scanning presets.

The radio will only scan stations with a strong signal that are in the selected band.

Setting Preset Stations

Up to 30 stations (six FM1, six FM2, and six AM,

six XM1 and six XM2 (if equipped)), can be programmed on the six numbered pushbuttons, by performing the following steps:

1.Turn the radio on.

2.Press BAND to select FM1, FM2, AM, or XM1 or XM2.

3.Tune in the desired station.

4.Press AUTO EQ to select the equalization.

5.Press and hold one of the six numbered pushbuttons until you hear a beep. Whenever that numbered pushbutton is pressed, the station that was set will return and the equalization that was selected will be stored for that pushbutton.

6.Repeat the steps for each pushbutton.

3-84