Buick 2006 manual Playing a CD Single CD Player, Radio Display Condition Action Required

XM™ Radio Messages (cont’d)

Radio Display	Condition	Action Required
Message
Radio ID	Radio ID label (channel 0)	If tuned to channel 0, this message will alternate with the
		XM™ Radio eight digit radio ID label. This label is needed
		to activate the service.
Unknown	Radio ID not known	If this message is received when tuned to channel 0, there
	(should only be if	may be a receiver fault. Consult with your GM dealer.
	hardware failure)
Chk XMRcvr	Hardware failure	If this message does not clear within a short period of time,
		your receiver may have a fault. Consult with your GM
		dealer.

Playing a CD (Single CD Player)

Insert a CD partway into the slot, label side up. The player will pull it in and the CD should begin playing.

If the ignition or radio is turned off with a CD in the player, it will stay in the player. When the ignition or radio is turned on, the CD will start playing where it stopped, if it was the last selected audio source.

When a CD is inserted, CD and the CD symbol

will appear on the display. As each new track starts to play the track number will appear on the display.

The CD player can play the smaller 3 inch (8 cm) single CDs with an adapter ring. Full-size CDs and the smaller CDs are loaded in the same manner.

If playing a CD-R, the sound quality may be reduced due to CD-R quality, the method of recording, the quality of the music that has been recorded, and the way the CD-R has been handled. There may be an increase

in skipping, difficulty in finding tracks, and/or difficulty in loading and ejecting. If these problems occur, check the bottom surface of the CD. If the surface of the CD is damaged, such as cracked, broken, or scratched, the CD will not play properly. If the surface of the CD

is soiled, see “Care of Your CDs” later in this section.

If there is no apparent damage, try a known good CD.

3-90