Buick 2006 manual To Use the Engine Coolant Heater

3.If your engine still will not start, or starts but then stops, it could be flooded with too much gasoline. Try pushing your accelerator pedal all the way to the floor and holding it there as you hold the key in START for a maximum of 15 seconds. This clears the extra gasoline from the engine. If the engine still will not start, or starts briefly but then stops again, repeat Step 1 or 2, depending on the temperature. When the engine starts, release the key and the accelerator pedal.

Notice: Your engine is designed to work with the electronics in your vehicle. If you add electrical parts or accessories, you could change the way the engine operates. Before adding electrical equipment, check with your dealer. If you do not, your engine might not perform properly. Any resulting damage would not be covered by your vehicle’s warranty.

Engine Coolant Heater

Your vehicle may have an engine coolant heater. In very cold weather, 0°F ( −18°C) or colder, the engine coolant heater can help. You will get easier starting and better fuel economy during engine warm-up. Usually, the coolant heater should be plugged in a minimum of

four hours prior to starting your vehicle. At temperatures above 32°F (0°C), use of the coolant heater is not required. Your vehicle may also have an internal thermostat in the plug end of the cord. This will prevent operation of the engine coolant heater when the temperature is at or above 0°F ( −18°C) as noted on the cord.

To Use the Engine Coolant Heater

1.Turn off the engine.

2.Open the hood and unwrap the electrical cord. The electrical cord is located on the driver’s side of the engine compartment.

3.Plug it into a normal, grounded 110-volt AC outlet.

2-34