GS110TP Hardware Installation Guide

Step 3: Checking the Installation

Before applying power to the switch, perform the following:

Inspect the equipment thoroughly.

Verify that all cables are installed correctly.

Check cable routing to make sure cables are not damaged or creating a safety hazard.

Ensure all equipment is mounted properly and securely.

Step 4: Connecting Devices to the Switch

The following procedure describes how to connect PCs to the switch’s RJ-45 ports. The GS110TP Smart PoE Switch contains Auto Uplink technology, which allows the attaching of devices using either straight-through or crossover cables.

Link/Act PoE

PROSAFE GS110TP

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Link/Act Mode

 

 

 

Green=Link at 1000M

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PoE Max

Yellow=Link at 100M/10M

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Blink=ACT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PoE Mode

 

 

 

Green=PoE Powered

 

9F

10F

Yellow=PoE Fault

PoE

Link/Act

Link/Act

 

Ports

 

 

`

`

Desktop PC

Desktop PC

Figure 4-1

Installation

4-3

v1.0, March 2010

Page 19
Image 19
NETGEAR GS110TP-100NAS manual Checking the Installation, Connecting Devices to the Switch, Desktop PC