GS110TP Hardware Installation Guide

The GS110TP Smart PoE Switch is a free-standing switch. It is IEEE-compliant and offers low latency for high-speed networking. All ports can automatically negotiate to the highest speed. This capability makes the switch ideal for environments that have a mix of Ethernet, Fast Ethernet, or Gigabit Ethernet devices. In addition, all RJ-45 ports operate in half-duplex or full-duplex mode. The maximum segment length is 328 feet (100 meters) over Category 5 Unshielded Twisted-Pair (UTP) cable.

Features

The following list identifies the key features of the GS110TP Smart PoE Switch:

Eight RJ-45 10/100/1000 Mbps autosensing Gigabit Ethernet switching ports.

Two 1000M SFP Gigabit Ethernet switching ports.

Full NETGEAR Smart Switch functionality.

Full compatibility with IEEE standards:

IEEE 802.3 CSMA/CD

IEEE 802.3i (10BASE-T)

IEEE 802.3u (100BASE-TX)

IEEE 802.3x (Full-duplex flow control)

IEEE 802.3ab (1000BASE-T)

IEEE 802.3z (1000BASE-x)

IEEE 802.3af (DTE power via MDI)

Autosensing and auto-negotiating capabilities for all ports.

Auto Uplink™ on all ports to make the right connection.

Automatic address learning function to build the packet-forwarding information table. The table contains up to 4K Media Access Control (MAC) addresses.

Store-and-Forward transmission to remove bad packets from the network.

Full-duplex IEEE 802.3x pause frame flow control.

Active flow control to minimize packet loss and frame drops.

Half-duplex backpressure control.

Per port LEDs, power LED.

1-2

Introduction

v1.0, March 2010

Page 8
Image 8
NETGEAR GS110TP-100NAS manual Features