Since there are many different makes and models of vehicles, look at the wiring chart on or our website, www.bulldogsecurity.com/wires.htm.
Read this manual thoroughly before starting the installation. You must decide if the parking light option is desired. An optional part #775 will be needed. Please do not skip any steps.
TACH/TACHLESS OPERATION
In most cases the decision to go with tachless mode will save time during the installation. If your vehicle is
MAKE SURE YOU PLACE THE WARNING STICKER UNDER YOUR HOOD.
PRECAUTIONS
This system is designed to be used with fuel-injected,
automatic transmission vehicles only.
SAFETY FIRST!
Never start your vehicle if it is indoors, if the keys are in the ignition and you’re sure the car is in park. A periodic safety check is recommended to ensure that your system is in proper working order.
DO NOT use mechanical wiring connections, such as crimp or snap together taps. Follow instructions below.
DO NOT disconnect the battery if the vehicle has an
DO NOT leave the interior or exterior lights on for an extended period of time as it may cause battery drain. Remove the dome light fuse from the fuse box. NOTE: Starter systems do not work well with a partially discharged battery.
DO NOT mount the control module until all connections have been made and tested. Using wire ties or double sided tape, MOUNT THE MODULE UNDER THE DASH. Place the warning sticker under the hood.
WARNING!
GENERAL MOTORS REAR WHEEL DRIVE VEHICLES AND DODGE DAKOTAS
All General Motors rear wheel drive vehicles and Dodge Dakotas built prior to 1996 do not have an electrical Neutral Safety switch. They have a mechanical neutral safety switch. The mechanical neutral safety switch operates as follows.
a)The key will only turn to start position when the gear selector is in park or neutral. b)The key can only be removed from the ignition switch when the gear selector is in the park
position.
You must use special precautions with this system. For more information see page 7.
MAKING WIRING CONNECTIONS
1.Strip back two inches of insulation on the wire from the keyless entry. Two Inches of Bare Wire
2.Strip back one inch of insulation on the wire you need to connect to. One Inch of Bare Wire
3.Separate the vehicle wire as shown. Make the separation large enough to fit the other wire through.
2
