Bulldog Security RS82 CONNECTING THE 11-PIN HARNESS & 4-RELAY HARNESS, Neutral Safety Switch

CONNECTING THE 11-PIN HARNESS & 4-RELAY HARNESS

	RED		To +12V constant
	BLACK		Ground
	BROWN		(-) Parking Light Output 250ma
			(Requires optional part #775)
	BLUE/BLACK		(+) Brake Switch
	YELLOW/BLACK		Ignition Input
	BLUE		(-) Aux. Alarm Channel Input
	BLACK/BLUE		(-) To Hood Pin Switch
	BLACK/WHITE		Tach to (-) Neg. Side of Coil
	RED/BLACK		(-) Factory Alarm Shutdown
WHT/BLK 16 ga.	GRAY		(Not Used)
WHITE 16 ga.				YELLOW ANTENNA
YEL/BLK 16 ga.				Keep as straight as
		750ma (-)		possible, tape end
		Outputs		to hold straight.

	RED	3 Red wires need +12V
	RED
	RED	constant.
For Passlock I	WHITE	Either white wire to
WHT/BLK 16 ga	WHITE	Ignition 1. If your
		car has 2 ignitions
For Passlock II		use both.
	YELLOW/BLACK	To Starter/Crank Wire
WHITE 16 ga
For Passlock I		To Accessory Wire(s) that
YEL/BLK 16 ga	WHITE/BLACK	run the Heater/Blower
		Motor. Attach at the
Tap here when		ignition switch wire
		harness only.
installing bypass
module 721.

CAUTION: Before connecting the 11-pin harness to the module, double check all connections to be sure they are secure and properly wrapped with electrical tape. Plug the 11-pin harness into the main control module. Connect the 3-pin harness from the 4-relay harness to the module. NOTE: The GRAY wire in the 11-pin harness will not be used. Tape this wire up.

Press the start button, if your vehicle does not start and run you may have a factory anti-thet system. Refer to page 7 to see if this applies to your vehicle.

NEUTRAL SAFETY SWITCH

PRE-1996 GM REAR WHEEL DRIVES WITH PURPLE CRANK WIRE – Optional part #775 required.

MECHANICAL NEUTRAL SAFETY SWITCH (Rear Wheel Drive Only)

When installing a Bulldog remote starter on GM vehicles or Dodge Dakotas built prior to 1996, you must: Use the diagram below to create a circuit that will prevent the remote starter from starting the vehicle unless the key is removed from the ignition switch.

	Driver’s Door Switch							YELLOW
	TAN			Tie into	WHITE	86	87	85			BLACK
				heavy white
Key					5 Amp		87a
				wire on
				4-relay
Cylinder				harness	fuse			30
			Ground			BLUE			Ground		RED
GREEN										NOT USED,
					(-) Negative					TAPE OFF
					hood pin wire
		Message
		center or
		key buzzer

PRE-1996 DODGE DAKOTAS

Optional part #775 required.

Driver’s Door Switch

YELLOW

BLACK/LT.BLUE

Ground

Tie into

86

87

85

Ground

WHITE

BLACK

heavy white

Key

wire on

5 Amp

87a

4-relay

Cylinder

harness

fuse

30

BLUE

RED

LT.BLUE/GREEN

NOT USED,

TAPE OFF

(-) Negative

hood pin wire

Message

center or

key buzzer

6