4. Insert the wire from the unit through the hole as shown.
5.Wrap the wire around one side then the other and finally around itself as shown. 2 1
3
6.Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the connection. First pull the wire that you have just connected along side the wire you connected to, tape and wire tie them together. Use this method for all connections.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Wire Tie |
| Electrical Tape |
| |
|
|
|
|
|
| |||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| |
CAUTION: All wires must be wrapped and taped.
MAKING END TO END CONNECTIONS
FOLLOW THESE INSTRUCTIONS
1.When tying two separate wires together at their ends, strip back 1” of insulation on both wires and separate the strands of wire as shown below.
2.Twist upper wires together, twist lower wires together as shown.
3.Lay upper twisted pair of wires over right wire as shown. Bring lower twisted pair of wires up to meet the left wire as shown.
3
