Bunn 41722.0000A manual Non Lighted, Switch is located on the front control panel

SERVICE (cont.)

ON/OFF SWITCH-TB6/Q (Sweetner ½ Batch Option-TB3/Q)
	WHI/VIO
	BLACK
	PINK
	optional
P/N 03356.0003	½ batch
	GRAY
Non Lighted
	Optional
	½ batch
FIG. 15-1 NON LIGHTED ON/OFF SWITCH	FULL/OFF/HALF-TB3/TB3Q
Location:	WHI/VIO
The switch is located on the front control panel.
Test Procedure:	WHITE
1. Disconnect the brewer from the power source.
2. Disconnect the wires from switch terminals.	BRN/WHI
3. Check for continuity across the center and right
and across center and left terminals in rows one	WHI/GRN
through four when the switch is in the oposite
position.	BLACK
If continuity is not present as described, replace the	WHI/VIO
switch.	UNSWEET/OFF/SWEET-TB3/TB3Q
If continuity is present as described, replace the wires
	w/SWEETENER & EMPTY DETECT
the switch is operating properly.
Removal and Replacement:	WHI/VIO
1. Remove the wires from the switch terminals.
2. Remove the clips on the switch bezel inside the
hood and gently push the switch through the	YELLOW
opening.
3. Push the new switch into the opening from inside	BLACK
the hood and secure into place by pressing the
bezel through the front of the hood. Make sure
the clips on the switch bezel are locked around
the switch housing and spread the clips to hold	BRN/BLK
the switch captive in the hood.	LEFT/OFF/RIGHT-TB6
4. Refer to FIG. 15-2 when reconnecting the wires.
	FIG. 15-2 ON/OFF SWITCH TERMINALS
Page 15	41722 070209