SERVICE (cont.)
LAMP HOLDER
| 1 |
|
|
| 2 |
|
| 3 |
|
| 4 |
|
| 5 |
6 |
| 2 |
|
| |
| FIG. 16 LAMP HOLDERS | P1209.75 |
|
|
1. | Door Assy | 4. | Upper Cover W/Reflec- |
2. | Lamp Holders |
| tor |
3. | Lamp | 5. | Lower Cover |
6.Starter W/Socket
Location:
The lamp holders are located on the front of the reflector behind the display panel.
Test Procedure:
1.Disconnect the dispenser from the power source.
2.Disconnect the plugs on the door wiring harness from the connectors on the lamp holders.
3.Remove lamp from lamp holders.
4.Disconnect the two pin plugs of each lamp holder from the door wiring harness.
5.Check for continuity on each lead of the lamp holders.
If continuity is present as described, lamp holders are operating properly.
If continuity is not present as described replace the lamp holder.
Removal and Replacement:
1.Open dispenser door (1).
2.Remove the six
3.Disconnect the door wiring harness from the door interconnect wiring harness.
4.Remove eight
5.Remove the upper door cover w/reflector (4), lamp (3), lamp holders (2) and door wiring har- ness as a assembly.
6.Rotate lamp (3) 90° and remove from lamp hold- ers (2).
7.Remove the
8.Install new lamp holder (2) and secure with a #6- 32 screw.
9.Install lamp (3) into lamp holders (2) and turn 90° until the pins snap in place.
10.Install upper door cover w/reflector (4), lamp (3), lamp holders (2) and door wiring harness as a assembly using eight
11.Reconnect the plug on the door wiring harness to the connector on the door interconnect wiring harness.
12.Install the door bottom cover (5) using six
LAMP REPLACEMENT (Refer to Fig. 16)
1.Open the dispenser door (1).
2.Remove the upper door cover w/reflector (4), lamp (3), lamp holders (2) as an assembly.
3.Rotate lamp (3) 90° and remove from the lamp holders (2).
4.Insert new lamp (3) into lamp holders (2) and turn 90° until the pins snap in place.
5.Reinstall upper door cover w/reflector (4), new lamp (3) and lamp holders (2) on the door assy (1).
24 | 27591 031597 |
|
