PROGRAMMING
The programming of the brewer is divided into two levels. There is one function in Level 1. All other functions are accessed in Level 2.
The following function screens are in order of appearance. Each screen will have instructions on how to access and the procedures for programming the various functions of the brewer.
IMPORTANT PROGRAMMING NOTES
- READ CAREFULLY -
To exit the programming mode at any time, press and release either ON/OFF pad located on the front switch panel. The display will return to the MAIN SCREEN.
If none of the five programming switches are pressed within one minute during the setup of the brewer, the programming of the function screen that is being set will be exited and the display will return to the MAIN
SCREEN.
Always remember to place a container and funnel under the sprayhead when operating the brewer during the
MAIN SCREEN
READY TO BREW
WATER TEMP: 200°
For additional information, you can download the programming manual at www.bunn.com
P2426
This screen will be shown when the brewer is ready for use. The screen displays the water temperature in the tank. When the water in the tank reaches the correct set temperature, the display will change from HEATING to READY TO BREW.
PROGRAMMING LOCKOUT SWITCH (located on the memory module board prior to S/N ICB001330
-located on the main circuit board S/N ICB001330 and after)
This switch can be set to prevent access to the programming settings of the brewer. Once all the cor- rect brew settings are programmed, the operator can set the switch to the "ON" position to prohibit anyone from changing the settings. With the switch in the "ON" position, the programming menus can still be accessed to view the current settings. However, no changes will be saved.
UNLOCK | MEMORY |
| |
LOCK |
|
PROGRAMMING
LOCKOUT SWITCH
P3048
For more advanced PROGRAMMING information, refer to programming manual 41581.0001 at www.bunn.com
Page 11 | 41581 120408 |
|
