Burris LH 3, LH 3000, LH 4, LH 6000

Chapter 2 Remove Bezel, Cover, and Components

WARNING Before removing the cover, always disconnect the power

cord(s) and unplug telephone cables. Disconnect the power

cord(s) to avoid exposure to high energy levels that may cause

burns when parts are short-circuited by metal objects, such as

tools or jewelry. Disconnect telephone cables to avoid

exposure to shock hazard from telephone ringing devices.

Note that the power switch does not turn off the standby

power. Disconnect the power cord(s) to turn off standby

power. If the backlight on the LCD display is on, standby

power is still on.

CAUTION Never operate this HP NetServer without first installing the

covers and the front bezel. Operating the system without the

covers in place reduces critical cooling airflow over some

components, such as power supply modules, hard disk drives,

and processor modules. Operating the system without the

covers in place may result in failure of these components.

If you open the HP NetServer LH 3/3r or LH 4/4r while it is

operating, do not run it for more than 2 minutes. If you op e n

the HP NetServer LH 3000/3000r or LH 4000/4000r while it

is operating, do not run it for more than 60 minutes. Failure to

observe these precautions may result in thermal damage to the

NetServer.

CAUTION Wear a wrist strap and use a static-dissipating work surface

connected to the chassis when you remove or install

components.