Burris LH 3, LH 3000, LH 4, LH 6000 - page 26

Chapter 3 Conversion: Install Components, Cover, and Front Bezel
22
4. Rotate the control panel until it is aligned with the rack position of the
NetServer, as shown in Figure 3-3. Be careful of the ribbon cable that
connects the control panel to the NetServer. Be careful not to damage it.
Compaqrack slots (on left)
Control Panel
HPrack slots (on right)
Figure 3-3. Reorient Control Panel to NetServer Chassis
NOTE There are two possible positions for the reinstallation of the
control panel, depending upon the rack in which the NetServer
will reside. Refer to Figure 3-3.
5. Refer to Figure 3-3. Mount the control panel in the set of slots appropriate
for your rack:
◊ Slots for the HP rack are on the right.
◊ Slots for the Compaq rack are on the left.