Burris LH 3, LH 3000, LH 4, LH 6000

Chapter 3 Conversion: Install Components, Cover, and Front Bezel

Attach the Front Bezel

After the new front bezel is prepared, push it into place, as shown in Figure 3-11

or 3-12.

Figure 3-11. Push Front Bezel into Place on HP Rack

Contents

Main Notice Audience Assumptions Contents Page Preface About this Guide Related Documentation Tools You Need 1 Introduction Overview Warnings Page Verify Contents Prepare for Installation Page 2 Remove Bezel, Cover, and Components Overview of Removal of Front Bezel, Rack Rail Cover, and Components Disconnect the NetServer Page Remove the Front Bezel and Rack Rail Cover Remove the Front Bezel Remove the Rack Rail Cover Page Lighten the NetServer Remove Hot-Swap Hard Disk Drives Remove Power Supply Modules Page Move the NetServer Remove the Casters Page 3 Conversion: Install Components, Cover, and Front Bezel Overview of Conversion to Rack-Optimized Configuration Install Memory or Accessory Boards Page Reorient the Control Panel Page Page Install the NetServer in the Rack Page Page Page Page Attaching the Cable Management Arm Page Page Install Chassis Retention Bracket when Shipping an HP Rack Install the New Front Bezel Prepare the Front Bezel Page Page Reconnect the Power Cords and Cables Page 4 Warranty and Support Hardware Accessories Limited Warranty Hewlett-Packard Hardware Accessories Third-Party Hardware Products HP Repair and Telephone Support Page Page Index