Burris LH 3, LH 3000, LH 4, LH 6000

Chapter 3 Conversion: Install Components, Cover, and Front Bezel

Bezel Hinge

LatchAssembly

Figure 3-6. Mounting Hardware for Front Bezel for HP Rack

◊ For the Compaq rack, the bezel mounting hardware is the left and

right recessed brackets, as shown in Figure 3-7. The left recessed

bracket is a long part with four screw holes. The right recessed bracket

is a small metal part with four screw holes, but no latch. Attach this

hardware as described in the HP NetServer LH 3r, LH 4r, LH 3000r,

and LH 6000r Installation Guide for Compaq® 4000/7000 Racks.

Contents

Main Notice Audience Assumptions Contents Page Preface About this Guide Related Documentation Tools You Need 1 Introduction Overview Warnings Page Verify Contents Prepare for Installation Page 2 Remove Bezel, Cover, and Components Overview of Removal of Front Bezel, Rack Rail Cover, and Components Disconnect the NetServer Page Remove the Front Bezel and Rack Rail Cover Remove the Front Bezel Remove the Rack Rail Cover Page Lighten the NetServer Remove Hot-Swap Hard Disk Drives Remove Power Supply Modules Page Move the NetServer Remove the Casters Page 3 Conversion: Install Components, Cover, and Front Bezel Overview of Conversion to Rack-Optimized Configuration Install Memory or Accessory Boards Page Reorient the Control Panel Page Page Install the NetServer in the Rack Page Page Page Page Attaching the Cable Management Arm Page Page Install Chassis Retention Bracket when Shipping an HP Rack Install the New Front Bezel Prepare the Front Bezel Page Page Reconnect the Power Cords and Cables Page 4 Warranty and Support Hardware Accessories Limited Warranty Hewlett-Packard Hardware Accessories Third-Party Hardware Products HP Repair and Telephone Support Page Page Index