14Fig. 1
Charging the ONIX 110 Battery
Before using your ONIX 110 for the first time, the internal rechargeable battery must be fully charged, via the USB port on the unit. Connect the supplied USB cable to the ONIX 110, then connect the other end of the cable to the AC Charger. Plug the charger into an AC wall outlet, and allow the unit to charge until the battery charge icon on the unit’s display indicates a full charge (this typically takes
Turning On For the First Time
To turn on your ONIX 110 Handheld GPS Navigator, press and hold the Power button for two seconds. The product information page is displayed.
Next, the Mode Selection menu appears. Use the navigation keys to select the mode you want and press the OK button to confirm.
Press the Menu button twice and select Satellite. The ONIX 110 starts acquiring satellite information as described in the following section.
Acquiring Satellite Information
The satellite page displays information obtained from the GPS satellites (Fig. 1). The upper half of the screen displays the satellites found in the vicinity and their respective numbers.
NOTE: In order to operate each mode at its optimal performance, the ONIX 110 must have its position determined by the satellites.